Details

Product introduction

MVR evaporator is a new energy efficient evaporation device is mainly used in pharmaceutical industry, the low temperature and low pressure steam equipment technology and clean energy for energy will produce steam, medium water is separated, is the current international advanced evaporation technology, products to replace the traditional evaporator upgrade.

MVR evaporator is different from the ordinary single effectfalling film or multi effect falling film evaporator, MVR single evaporator, multi effect falling film evaporator in a body, according to the required concentration of different products adopt step evaporation, namely the product in the first pass effect body cannot reach the required concentration, in effect leaving body after the vacuum pump efficiency will lower body products through effective external pipeline pumping to the upper body effect again through the effect, and then by the repeated through the body to the desired concentration.

Effect of body is arranged in the tube, pipe internal product, external steam flow process, in which the products in the area because the pipe increases product membranous flow, to increase the heating area, the negative pressure formed in the body through the effect of vacuum pump, reduce water boiling point, in order to concentrate the product, the evaporation temperature is about 60 degrees.

The products produced by the effect of heating after evaporation of condensed water, steam and heating effect of residual steam through the separator for separation, condensed water outflow from the bottom of the separator is used for preheating the body into the efficiency of products, steam pressurization by fan booster (steam pressure the greater the higher the temperature, and then through the booster) the steam pipe through a confluence of steam again through the body.

When the device starts to preheat a part of steam, the steam will greatly reduce the normal operation, in the process of the two fan booster to the steam pressure in the steam electric energy into heat energy, so the equipment required for the operation of the steam reduction process, which required a substantial increase in power.

In the whole process flow in the effect of temperature is always at about 60 DEG between the heating steam and the temperature difference of the products are maintained at 5 - 8 DEG C, between the product and the heating medium temperature difference of the smaller and more conducive to the protection of the quality of the products, effectively prevent the paste tube. When the concentration of the product is about 50%, the evaporator can only be completed by MVR. When the concentration is 60%, the flash equipment should be installed.

Company information

Shandong Luli medicine equipment manufacturing and installation Co. Ltd. is a company engaged in the extraction, concentration and drying engineering technology development of high-tech enterprises, specializing in the extraction, concentration and drying technology and equipment research and development, design, manufacture, installation, commissioning and technical consultation!

Counseling hotline : 400-011-0271